It affects only how lengths, angles, and coordinates are displayed in the user interface. Changing the unit format and precision does not affect the internal precision of your drawing. If you plan to use metric units, leave the unit type set to Decimal. If you plan to work in feet and inches, set the unit type to Architectural, and then when you create objects, specify their lengths in inches, or by using (') for feet and (") for inches. For example, a decimal length of 6.5 can be set to display as 6.50, 6.500, or 6.5000. For example, a decimal length of 6.5 can be set to display as a fractional length of 6-1/2 instead. Here you can control several unit display settings including the following: For example, the objects below could represent two buildings that are each 125 feet long, or they could represent a section from a mechanical part that is measured in millimeters.Ĭlick Settings on the right side of the header, and go to the Units tab. For example, if you position the cursor in the upper-right area of the floor plan as shown below, rolling the mouse wheel magnifies that area without shifting it.Īfter you start a new drawing, you'll first decide what the length of one unit represents-an inch, a foot, a centimeter, a kilometer, or some other unit of length. Think of your cursor as a magnifying glass. Tip: When you zoom in or out, the location of the cursor is important.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |